PassLeader just published the NEWEST Fortinet NSE4_FGT-7.0 exam dumps! And, PassLeader offer two types of the NSE4_FGT-7.0 dumps — NSE4_FGT-7.0 VCE dumps and NSE4_FGT-7.0 PDF dumps, both VCE and PDF contain the NEWEST NSE4_FGT-7.0 exam questions, they will help you PASSING the Fortinet NSE4_FGT-7.0 exam easily! Now, get the NEWEST NSE4_FGT-7.0 dumps in VCE and PDF from PassLeader — https://www.passleader.com/nse4-fgt-7-0.html (125 Q&As Dumps –> 189 Q&As Dumps)
What’s more, part of that PassLeader NSE4_FGT-7.0 dumps now are free — https://drive.google.com/drive/folders/1B5ElSMmGwQVzy1-a4lXWfn9fw0jmDY_0
NEW QUESTION 101
Which statements best describe auto discovery VPN (ADVPN)? (Choose two.)
A. It requires the use of dynamic routing protocols so that spokes can learn the routes to other spokes.
B. ADVPN is only supported with IKEv2.
C. Tunnels are negotiated dynamically between spokes.
D. Every spoke requires a static tunnel to be configured to other spokes so that phase 1 and phase 2 proposals are defined in advance.
NEW QUESTION 102
Which two inspection modes can you use to configure a firewall policy on a profile-based next- generation firewall (NGFW)? (Choose two.)
A. Proxy-based inspection.
B. Certificate inspection.
C. Flow-based inspection.
D. Full Content inspection.
NEW QUESTION 103
Which two statements are correct regarding FortiGate FSSO agentless polling mode? (Choose two.)
A. FortiGate points the collector agent to use a remote LDAP server.
B. FortiGate uses the AD server as the collector agent.
C. FortiGate uses the SMB protocol to read the event viewer logs from the DCs.
D. FortiGate queries AD by using the LDAP to retrieve user group information.
NEW QUESTION 104
An administrator is configuring an Ipsec between site A and site B. The Remotes Gateway setting in both sites has been configured as Static IP Address. For site A, the local quick mode selector is 188.8.131.52/24 and the remote quick mode selector is 184.108.40.206/24. How must the administrator configure the local quick mode selector for site B?
NEW QUESTION 105
Which CLI command allows administrators to troubleshoot Layer 2 issues, such as an IP address conflict?
A. get system status
B. get system performance status
C. diagnose sys top
D. get system arp
NEW QUESTION 106
Which two statements ate true about the Security Fabric rating? (Choose two.)
A. It provides executive summaries of the four largest areas of security focus.
B. Many of the security issues can befixed immediately by click ng Apply where available.
C. The Security Fabric rating must be run on the root FortiGate device in the Security Fabric.
D. The Security Fabric rating is a free service that comes bundled with alt FortiGate devices.
The security rating uses real-time monitoring to analyze your Security Fabric deployment, identify potential vulnerabilities, highlight best practices that can be used to improve the security and performance of your network, and calculate Security Fabric scores. To view the security rating, go to Security Fabric > Security Rating on the root FortiGate. The Security Rating page is separated into three major scorecards: Security Posture, Fabric Coverage, and Optimization, which provide an executive summary of the three largest areas of security focus in the Security Fabric.
NEW QUESTION 107
What types of traffic and attacks can be blocked by a web application firewall (WAF) profile? (Choose three.)
A. Traffic to botnetservers.
B. Traffic to inappropriate web sites.
C. Server information disclosure attacks.
D. Credit card data leaks.
E. SQL injection attacks.
NEW QUESTION 108
A network administrator wants to set up redundant IPsec VPN tunnels on FortiGate by using two IPsec VPN tunnels and static routes:
– All traffic must be routed through the primary tunnel when both tunnels are up.
– The secondary tunnel must be used only if the primary tunnel goes down.
– In addition, FortiGate should be able to detect a dead tunnel to speed up tunnelfailover.
Which two key configuration changes are needed on FortiGate to meet the design requirements? (Choose two,)
A. Enable Dead Peer Detection.
B. Configure a lower distance on the static route for the primary tunnel, and a higher distance on the static route for the secondary tunnel.
C. Enable Auto-negotiate and Autokey Keep Alive on the phase 2 configuration of both tunnels.
D. Configure a higher distance on the static route for the primary tunnel, and a lower distance on the state route for the secondary tunnel.
NEW QUESTION 109
Which two settings can be separately configured per VDOM on a FortiGate device? (Choose two.)
A. System time.
B. FortiGuaid update servers.
C. Operating mode.
D. NGFW mode.
NEW QUESTION 110
Which statements are true regarding firewall policy NAT using the outgoing interface IP address with fixed port disabled? (Choose two.)
A. This is known as many-to-one NAT.
B. Source IP is translated to the outgoing interface IP.
C. Connections are tracked using source port and source MAC address.
D. Port address translation is not used.
The fixed port is disabled default, fixed port disabled means that source port translation can be used.
NEW QUESTION 111
To complete the final step of a Security Fabric configuration, an administrator must authorize all the devices on which device?
B. Root FortiGate
D. Downstream FortiGate
All devices must be authorized on the root Fortigate, and then after this step all must be authorized on the FortiAnalyzer.
NEW QUESTION 112
By default, FortiGate is configured to use HTTPS when performing live web filtering with FortiGuard servers. Which two CLI commands will cause FortiGate to use an unreliable protocol to communicate with FortiGuard servers for live web filtering? (Choose two.)
A. set fortiguard anycast disable
B. set protocol udp
C. set webfilter-force-off disable
D. set webfilter-cache disable
NEW QUESTION 113
An administrator observes that the port1 interface cannot be configured with an IP address. What can be the reasons for that? (Choose three.)
A. The interface has been configured for one-arm sniffer.
B. The interface is a member of a virtual wire pair.
C. The operation mode is transparent.
D. The interface is a member of a zone.
E. Captive portal is enabled in the interface.
NEW QUESTION 114
An administrator Is configuring an IPsec VPN between site A and site B. The Remote Gateway setting in both sites has been configured as Static IP Address. For site A. the local quick mode selector is 220.127.116.11/24 and the remote quick mode selector is 192.168.2.0/24. Which subnet must the administrator configure for the local quick mode selector for site B?
NEW QUESTION 115
Which of the following are valid actions for FortiGuard category based filter in a web filter profile ui proxy-based inspection mode? (Choose two.)
NEW QUESTION 116
Which two protocol options are available on the CLI but not on the GUI when configuring an SD-WAN Performance SLA? (Choose two.)
NEW QUESTION 117
Which three authentication timeout types are availability for selection on FortiGate? (Choose three.)
NEW QUESTION 118
Which two attributes are required on a certificate so it can be used as a CA certificate on SSL Inspection? (Choose two.)
A. The keyUsage extension must be set to keyCertSign.
B. The common name on the subject field must use a wildcard name.
C. The issuer must be a public CA.
D. The CA extension must be set to TRUE.
NEW QUESTION 119
What information is flushed when the chunk-size value is changed in the config dlp settings?
A. The database for DLP document fingerprinting.
B. The supported file types in the DLP filters.
C. The archived files and messages.
D. The file name patterns in the DLP filters.
NEW QUESTION 120
On a FortiGate with a hard disk, how can you upload logs to FortiAnalyzer or FortiManager? (Choose two.)
B. real tune
NEW QUESTION 121
Learning the PassLeader NSE4_FGT-7.0 dumps with VCE and PDF for 100% passing Fortinet certification — https://www.passleader.com/nse4-fgt-7-0.html (125 Q&As Dumps –> 189 Q&As Dumps)
BONUS!!! Download part of PassLeader NSE4_FGT-7.0 dumps for free — https://drive.google.com/drive/folders/1B5ElSMmGwQVzy1-a4lXWfn9fw0jmDY_0